You are in Majorlift > Products > Transmission Jacks > PIT PTJ1000
 

If there's an easier, safer and quicker way to remove gearboxes, diffs and clutches, we'd like to hear about it. Roll along, remove, roll back, replace. The PTJ1000 , rated up to 1000kg, custom built to suit your pit, to tilt, turn and manoeuvre heavy transmissions to pin-point accuracy.

  • Load test certificate - supplied with each unit.
  • CE markings - conform to EC directives.
  • Capacity 1000kg.
 
Pit Transmission Jack VTJ1000P
A pit version of our Vertical Transmission Jack. Wheels are situated at each corner of a rectangular base rather than diagonally otherwise specification is as VTJ1000. This gives increased stability when running along a pit floor and is suitable for pits of 800mm minimum width.
 
 

 
 
The jack is pushed along the pit underneath the gearbox. The lifting adaptor is easily located into a precise position using the tilt and turn controls.
The diff or gearbox is lowered and rolled back along the pit. It can now be easily lifted away.
The repaired or new unit is then rolled back along the pit and raised into the exact position - the whole procedure can be safely handled by one person.