1

Minimum axle to ground clearance. Lowest vehicle in your fleet.

2.

2.

3.

Measurement of the depth of angle or channel section from the workshop floor.

4.

Width of pit, check this along the length of your pit at this point between pit rails, at 1 metre intervals as indicated on diagram.

5.

Width inside vertical flanges of the pit rails, at 1 metre intervals as indicated on diagram.

6.

Distance to the top of any lights, air or electricity supply that intrudes into the pit. (Left is your left when facing the operating controls of a pit jack)

7.

Distance from pit wall that any lights, air or electricity supply that intrudes into the pit. (Left is your left when facing the operating controls of a pit jack)

8.

Please advise of any other information on the pit construction not mentioned above that you think is relevant.

Please enter your contact information below

Enter your international code, dialling/area code and number